HVAC, Plumbing & Electrical Services in Gig Harbor, WA

What HVAC, Plumbing & Electrical Services Does Resicon Offer in Gig Harbor, WA?

For heating and cooling, plumbing, and electrical work, Gig Harbor homeowners turn to Resicon, all under one Washington-licensed roof. A cracked heat exchanger, an AC unit that’s stopped keeping up, or a dead outlet all get the same response: a technician who diagnoses the real cause before recommending a fix. Call 253-242-5306 or request service online to schedule.

Our shop sits about ten miles away in University Place, just across the Tacoma Narrows Bridge, so a Gig Harbor service call is a routine trip for us, not a special one.

WA Licensed & Bonded (RESICL874OF) | Mitsubishi Diamond Elite Contractor | 4.9★ from 400+ Google Reviews

Air Conditioning Repair, Installation & Replacement

Whether it’s a failing compressor, a refrigerant leak, or a condenser that’s given out mid-summer, air conditioning provides the repair, installation, and tune-up work to fix it, sized to the home through a full load calculation rather than matched to whatever unit was already there.

Homes along Harborview Drive and the older cottages near Gig Harbor’s historic netsheds sit close enough to the water that salt air reaches condenser coils daily, not just during storms, which shortens the life of an outdoor unit faster than it would a few blocks inland. A coil check built into every visit catches that corrosion before it turns into a full system failure.

Furnace Repair, Installation & Replacement

A furnace that won’t ignite, a failing blower motor, or a system that’s simply reached the end of its service life is what Resicon handles under furnace work, sizing any replacement to the home’s heating load and existing duct condition instead of swapping in a like-for-like unit.

A lot of Artondale’s homes sit on larger wooded lots built well before today’s efficiency codes, and the more rural stretches of the neighborhood are often running a furnace nobody’s serviced since it was installed. A pre-winter inspection catches a weak igniter or a cracked heat exchanger before the season’s first cold snap does.

Heat Pump Installation & Repair

Because one unit handles both sides of the year, a heat pump is increasingly the default over running a separate furnace and AC system, and heat pumps sizes the outdoor unit and indoor air handler to the home’s actual heating and cooling load.

The marine air around Wollochet Bay keeps summers milder and winters wetter than a lot of homeowners expect from the Pacific Northwest, which is exactly the kind of climate a heat pump is built for: efficient cooling for the occasional hot stretch without a furnace sitting idle most of the year.

Mini-Split & Ductless HVAC Services

For additions, converted spaces, and rooms that were never tied into central air, ductless systems mounts an indoor air handler directly where it’s needed, connected to an outdoor compressor through a line set that skips new ductwork entirely.

Fox Island’s homes often include guest cabins, boathouses, and additions built well after the main house, where running ductwork across the property was never realistic. A ductless system gets those spaces comfortable without trenching a line back to a central unit.

HVAC Maintenance Plans

A full electrical inspection, refrigerant charge verification, coil and filter check, condensate line clearing, and airflow measurement make up an HVAC maintenance visit, and Resicon puts that checklist on a fixed spring-and-fall schedule with priority booking for members.

The Maritime Gig Festival takes over downtown Gig Harbor’s waterfront every June, and it’s a useful annual marker for homeowners citywide: if your AC hasn’t been serviced since the last parade rolled down Harborview Drive, that’s a reasonable cue to get it inspected before summer demand hits.

Commercial HVAC Services

Rooftop package units, split systems, and light commercial refrigeration for Gig Harbor businesses fall under commercial, with repair calls prioritized on turnaround time since a failed unit during business hours costs more than the fix itself.

Retail and restaurant tenants throughout Uptown Gig Harbor run their rooftop units harder than a typical office building, especially through weekend shopping and dinner rushes, which changes how often that equipment needs a look compared to a lower-traffic commercial space.

Indoor Air Quality Services

Humidity, allergens, and stale air tend to be connected problems in a marine climate, not separate ones, and indoor air quality evaluates whole-home dehumidification, ventilation, and filtration together instead of treating them as separate fixes.

The bluff-front properties around Point Fosdick sit exposed to marine air moving in off the Tacoma Narrows, which pushes a heavier, more constant humidity load into these homes than properties set back from the water. A whole-house dehumidifier tied into the existing HVAC system handles that baseline moisture instead of leaving a portable unit to fight it room by room.

Electrical Repair, Wiring & Panel Services

Flickering lights, tripped breakers, and warm outlets are signs your electrical system needs a look, and electrical handles troubleshooting, rewiring, outlet and switch installation, and new circuit work with WA-licensed electricians who can explain what’s happening before recommending a fix.

A lot of the original wiring throughout Glen Cove was installed decades before homes commonly ran central air, an electric range, and a home office off the same panel, so a straightforward troubleshooting call there often turns up circuits that were adequate once but aren’t sized for what the house draws now.

Whole-House Generator Services

Gig Harbor’s power comes through Peninsula Light Company, a member-owned cooperative that’s served the area since 1925, and even a well-run utility can’t stop every outage, which is why Resicon installs and services residential generators sized to cover the essentials or the whole house, so an outage doesn’t mean a scramble.

In one recent equipment failure, Peninsula Light Company reported around 5,700 customers without power across the Gig Harbor area, with the outage map showing downtown, the Rosedale Street area, and the Hunt Street corridor among those affected. A generator sized ahead of time means the next one is an inconvenience instead of an emergency.

Plumbing Repair Services

New construction rough-in, remodel repiping, fixture installation, and general repair all fall under plumbing, with each job scoped against the property’s actual layout instead of a standard checklist applied regardless of the house.

The newer construction going up around Harbor Hill and Borgen Boulevard usually means plumbing plans built from scratch rather than matched to an existing system, so getting the rough-in right on the first pass matters more there than it does on a straightforward repair call.

Water Heater Repair, Installation & Replacement

Tank and tankless repair, replacement, and maintenance make up water heaters, sized to household hot water demand instead of swapped for whatever size unit was already there.

A lot of the homes built during Gig Harbor North’s growth over the past couple of decades are now reaching the age where their original water heater is due for replacement, even though the rest of the house still looks and feels new.

Drain Cleaning & Sewer Services

Kitchen, bathroom, and laundry line clogs get cleared through drain cleaning, using equipment built to cut through the blockage instead of just pushing it further down the line, with a camera inspection available when a clog keeps coming back.

Purdy’s history as one of the area’s original mill towns means some of its oldest properties are still connected to sewer infrastructure that predates current code, so a camera inspection there tends to turn up aging clay or cast-iron sections a newer line wouldn’t have.

Pipe Replacement & Repiping

Galvanized steel and aging copper lines prone to corrosion, leaks, and reduced water pressure are what repiping addresses, with each job scoped against the home’s pipe material and condition before any work begins.

Some of the oldest housing stock in Gig Harbor’s original In Town core still runs galvanized supply lines from the property’s initial construction, which is usually the real explanation behind gradually worsening water pressure that homeowners tend to blame on a fixture instead.

Why Gig Harbor Homeowners Choose Resicon

One licensed contractor covers HVAC, plumbing, and electrical work for Gig Harbor homeowners through Resicon, instead of three separate companies for a single project. The business goes back to 2013, when Vielka Ansari and Craig Christensen, who’d met working at a construction company together, took what’s been described as a leap of faith and applied for a small business loan to start their own company. It’s since grown into a 40-plus employee, minority woman-owned operation running eight crews a day, and Ansari’s path from loan officer to co-owner landed her on Inc. Magazine’s 2024 Female Founders 250 list.

The company has made the Inc. 5000 three times over (2019, 2020, and 2024), holds Mitsubishi Electric Diamond Elite Contractor status dating back to 2014, and carries a Master Installer designation with NW Ductless. Its Washington general contractor license (RESICL874OF) and electrical contractor license (RESICL#919N7) are both active, and it’s a preferred vendor for the King County Housing Authority and Pierce County Human Services.

Gig Harbor, WA HVAC, Plumbing & Electrical Questions, Answered

AC Repair vs. Replacement: How Do I Know Which One I Need?

Age, repair history, and cost are the main factors. A unit under ten years old with a single failed part is usually worth repairing, while one that’s needed multiple repairs, or would cost more than half of a replacement to fix, is typically the better candidate for replacement.

My cottage near the historic netsheds runs its AC constantly in summer. Is that normal?

Not necessarily. Homes this close to the water take on salt air daily, which corrodes a condenser coil faster than it would a few blocks inland, and a coil that’s already partway corroded has to work harder to move the same amount of heat. A technician can check coil condition and refrigerant charge to see whether that’s what’s driving the extra runtime.

Are Heat Pumps Worth It in Gig Harbor’s Climate?

For most homes, yes. The area’s mild, marine-influenced winters and short summer stretch let a heat pump cover both heating and cooling efficiently, without a separate furnace sitting mostly unused for months at a time, though the right fit still depends on the home’s existing ductwork and insulation.

I have a guest cabin on Fox Island with no ductwork. What’s my best option for heating and cooling it?

A ductless mini-split is usually the answer. It delivers both heating and cooling through a line set run from an outdoor compressor, without trenching new ductwork across the property to reach a detached structure. Our team can help you figure out how many zones a cabin or boathouse of your size needs.

Why Do Pipes Corrode Faster in Waterfront Gig Harbor Homes?

Salt-laden marine air and the higher humidity that comes with living close to the water speed up corrosion in galvanized pipe faster than a typical inland home experiences, often cutting years off a supply line’s expected lifespan. Homes closest to the waterfront tend to hit that point sooner than properties set further back.

Do I Need a Permit for HVAC, Plumbing, or Electrical Work in Gig Harbor?

In most cases, yes. Mechanical, plumbing, and electrical permits are typically required for equipment replacement and new installation work within city limits, and that paperwork gets handled as part of the job.

Does Living on the Water Affect What HVAC or Electrical Work My Home Needs?

It can. Homes directly on the water deal with more corrosion, more moisture, and more wind exposure than properties even a few blocks inland, so the system gets evaluated for its specific setting instead of treated the same as a home set back from the harbor.

Do You Service Areas Outside Gig Harbor?

Yes. Beyond Gig Harbor, Resicon also serves University Place, Tacoma, Lakewood, and the surrounding Pierce and Kitsap County communities.

Schedule HVAC, Plumbing & Electrical Service in Gig Harbor, WA

Whether it’s a heat pump replacement for a waterfront home on Wollochet Bay, a sewer camera inspection for an aging line in Purdy, or a panel upgrade for an older house near the harbor, Resicon brings the same licensed, no-upsell standard to every property in Gig Harbor. Call 253-242-5306 or request service online today to schedule your appointment.